The Mars 35W 26650 Mod is a massive 26650 mod originally from Ehpro.
Features:
1. Stainless steel body;
2.
Output Wattage: 7-35watt, it will allow you to fine-tune your vaping
experience by adjusting your power from 7W to 35W in increments of 0.1
watt;
3. Screen to show your: Output voltage, Output Wattage, Resistance, Battery Voltage & Battery power;
4. Engraved Mars logo & serialized;
5. Standard 510 connector.
Quick Instructions:
1.
Power on, press the power button 5 times to start up, “EHPRO” will show
in the screen first, “MARS” goes after and will enter into the home
page.
2. How to work, under the power-on state, long press the power
button to smoke, the mod will be no output if constantly pressing more
than 15S.
3. Screen Lock, press the Power button for 3 times to lock the device, and press the Power button 3 times again to unlock.
4.
Setup Mode, press the power button 5 times to enter the setup mode, the
button can also be used to set 3 modes: Power setting, EXIT and SYSTEM.
5.
Power setting, you can adjust the power after getting into the setting
mode, lean left to decrease power, lean right to increase power. The
range of the power adjustment should be between 7W to 35W with 0.1 Watt
step.
6. Back to the home page, after entering the setting mode, lean left or right can back to home page.
7.
Power-off, after entering the setting mode, press the power button to
select "SYSTEM", left or right tilted display will power off.
Attention:
1.“LOW
RES” displayed,Check Atomizer. It indicates the atomizer may be short
circuited. Check if any extra metal between atomizer and Control unit or
wrong assembly.
2.“CHECK BATTERY” displayed, maybe the voltage of battery is low, please recharge battery or change a new one.
3.“HHHHHHHH” displayed, Check Volts. It means the Volts is higher than rated voltage. Please replace with a new battery.
4.“NO
ATOMIZER” displayed, Check Atomizer. It indicates the device does not
detect atomizer. Or the atomizer is not normally connected.
5.“Too Hot! Please Wait” displayed, it means the temperature is high, please wait for a while before re-using.
WARRANTY: 30 day warranty for manufacturer defects. Note, the use of RBAs void the product warranty. Warranty does not cover misuse, whether intentional or not.